pushing the dash plugs into position

I started moving the dash plugs into position for the cluster and the headlight foglight switch which I knew would be a battle. I removed the driver's side vent and unscrewed the screws behind the cluster and the bottom corner of the dash to make some room. I passed cluster plug into the space where the headlight plug sit first. The forced it behind the plastic and metal frame while pushing on the vent hose. many cut and abrasions later I finally got those 3 plugs into place.
I pulled the hazard defrost and the dimmer and blower motor through. I attached the door chime airbag control plugs to there units.
i mounted the fuse box, 
couple more plugs to connect and I can zip tie the harness under the dash.

Popular posts from this blog

Flywheel, clutch, bell housing and some other details

Image
Installed the new flywheel.  Installed the new clutch.  Installed the clutch fork and throw out bearing  And then the bell housing  Installed a new transmission tailshaft seal.  I built a sled to drag it into place under the car and there's a bolt that fits the center of my jack through the center board. I may have to pull the shift cause there's exactly 19 inches under the pinch weld and thats the same to the shifter nub.
Read more

Oil pump and pick-up install

Image
12/10/2018 New oil pump and pickup tube installed and torqued to spec. This ones not mangled. Next is to check oil pan pick-up clearances and warm up the gasket and drape it over the pan for a while. I am probably going to have to heat the garage for 24 hours to get the rtv to set right.
Read more