Finished the wire tuck and mounted the motor mounts

I finished my wire tuck and have all the main harness hung up out of the way.
 I used fir tree zip ties to hang the harness under the pinch weld.
 The firewall looks good. I'll finish up the cowl work and put the hinge and cowl grill back.
Tucked and tied the wires up to the upper frame rail.
 Attached the power bus and made a good ground behind the corner of the ignition solenoid. Used dialectric grease to protect the steel and repaired a few grounds.
 The passager side.

I also mounted the motor mounts because it's almost time to dress the back of the engine.

Popular posts from this blog

Flywheel, clutch, bell housing and some other details

Image
Installed the new flywheel.  Installed the new clutch.  Installed the clutch fork and throw out bearing  And then the bell housing  Installed a new transmission tailshaft seal.  I built a sled to drag it into place under the car and there's a bolt that fits the center of my jack through the center board. I may have to pull the shift cause there's exactly 19 inches under the pinch weld and thats the same to the shifter nub.
Read more

Oil pump and pick-up install

Image
12/10/2018 New oil pump and pickup tube installed and torqued to spec. This ones not mangled. Next is to check oil pan pick-up clearances and warm up the gasket and drape it over the pan for a while. I am probably going to have to heat the garage for 24 hours to get the rtv to set right.
Read more