Rochester Carburetors

02/10/2019

I watched a very detailed video on rebuilding rochester carburetors. I have always been a fan of fuel injecton but i do plan on building an old school hotrod in the future so i figured i should start learning. I have had good luck cleaning and rebuilding them in small engines.

These carbs are found on many gm vehicles from the 70s and 80s.
https://youtu.be/ynl2_SqA8RQ

Popular posts from this blog

Flywheel, clutch, bell housing and some other details

Image
Installed the new flywheel.  Installed the new clutch.  Installed the clutch fork and throw out bearing  And then the bell housing  Installed a new transmission tailshaft seal.  I built a sled to drag it into place under the car and there's a bolt that fits the center of my jack through the center board. I may have to pull the shift cause there's exactly 19 inches under the pinch weld and thats the same to the shifter nub.
Read more

Oil pump and pick-up install

Image
12/10/2018 New oil pump and pickup tube installed and torqued to spec. This ones not mangled. Next is to check oil pan pick-up clearances and warm up the gasket and drape it over the pan for a while. I am probably going to have to heat the garage for 24 hours to get the rtv to set right.
Read more