New thermostat installed

05/13/2019

New thermostat installed.



Popular posts from this blog

Cooling system install

Image
I installed the cooling system yesterday. The upper rubber isolators were trashed so I asked my wife, what can you think of thats flat and rubber. She says how about old shoes. So I grabbed an old set of kids water shoes and some shears and just trimmed until they stuck into the brackets. I may paint them but for now it will work. I'll probably pick up all my fluids at once coolant, transmission, power steering. I still need a new fan. I am undecided on 2x 12 inch fans or replace the Taurus fan internals. The shroud is pretty nice but the draw is insane. I might just rewire it and give it a try with a new battery before I give up on it. I have a problem with my creeper it basically kicked all the bearings out of the casters. I have 4 nicer casters around the same size but the mounting points are 2x3 inches. So i am welding additions to the frame.
Read more

Flywheel, clutch, bell housing and some other details

Image
Installed the new flywheel.  Installed the new clutch.  Installed the clutch fork and throw out bearing  And then the bell housing  Installed a new transmission tailshaft seal.  I built a sled to drag it into place under the car and there's a bolt that fits the center of my jack through the center board. I may have to pull the shift cause there's exactly 19 inches under the pinch weld and thats the same to the shifter nub.
Read more

ecu capacitors installed

Image
So the capacitors arrived today and 1 hour and 40 minutes later they are installed and the ecu is back together.  I started by cleaning the rubber coating off the backside of the ecu around the solder pads with a finish nail. Just kinda scratched around the pads until it peeled and pulled pieces off with a tweezer. I grabbed the old capacitor with pliers and touched the iron to the backside until it sizzled and then started wiggling. One leg gave out and when I heated the other side it came loose. I bought a solder sucker so I put the remaining leg in the sucker facing the board upside down hanging off the desk and heated the solder from the back until the iron sank in and then hit the sucker release button and it cleared the hole and the leg. Some legs are kinda pushed to the side of the hole and I had to get a tweezer on and wiggle while heating the back. I was using a larger flat tip rather then a point. Point is easier for removing and the flat tip I like better to ...
Read more