heatcore part 3

Put another 2 hours and got pretty far on the heatercore replacement.
Removed the headlight and hazard switches. Removed the cluster shroud and disconnected the cluster and the speedo cable. 
Removed the dimmer switch which I knew needs a good cleaning. Check out the yummy green corrosion.
Removed the hood release and dropped the steering column.
Loosened the nut hidding under the steering column.
Removed the 2 bolts under the corner of the dash and the 5 in the speaker grills and the defroster vent. The dash came right down exposing the heater box.
I disconnected the heater hoses after I made a coolant catch tray out of and aluminum takeout tray and a water jug section. I bungied the hoses to the intake and put rubber glove fingers over the heater core inlets with rubber bands. And then we are outta time. 
Neighbor asked me to swap out the speed sensor on his f150 rear-end. Found a wire that was corroded, soldered and sealed that.

Popular posts from this blog

Flywheel, clutch, bell housing and some other details

Image
Installed the new flywheel.  Installed the new clutch.  Installed the clutch fork and throw out bearing  And then the bell housing  Installed a new transmission tailshaft seal.  I built a sled to drag it into place under the car and there's a bolt that fits the center of my jack through the center board. I may have to pull the shift cause there's exactly 19 inches under the pinch weld and thats the same to the shifter nub.
Read more

power steering rack line seals

Image
I finally decided to stop the leak that leaves a ton of fluid on my garage floor. I ordered the maximum motorsports rack seal kit. The instructions say you need to be clean before applying the sealant to the threads. I drained the rack and purged the rack after the lines were off so I could get rid of that little bit of fluid in the ports. i decided to completely remove and flush the lines to install the nylon seals. And have them stay clean through the install. the old one was chewed and the one that looks like new, wasn't installed right. Used the 2 screw driver method to gently stretch the rings out.  Then of course I take a break and get COVID. So 2 days later I am posting the pics.
Read more

water pump redo

Image
So with the change in temperature at the beginning of the year the water pump started sleeping when it was cold. This gradually got worse through the heat cycles. With corrosion evident on the bottom of the pump I decided to redo the water pump even though I am sure it could have just been resealed and been ok. I think I made 3 mistakes last time. I used the crap black gaskets that came with the pump. I used ultra grey rtv. I sealed the inner air pockets inside the pump. These filled with fluid and with the thermal expansion compromised the gasket. I went for a motorcraft pump this time as well as the light blue permatex rtv 22071. After I heatcycle the motor a few times I am going to go back and torque everything again. I also replaced the 2 left bolts that had corrosion on the from last time, with stainless ones. (5/16 - 18 4") I would have liked a 3 7/8" bolt but it's not available in stainless locally. I put a cut in an old bolt and chased the ...
Read more